Skip to main content
012 541 3596

WarriorTex Roll-On

WARRIORTEX™ ROLL-ON

Back to Acrylic Based Paints

Warriortex™ Roll-on is a high profile textured roll-on paint. It has been specially formulated to provide a hard wearing, decorative and protective finish.

USES :

Warriortex™ Roll-on can be used for interior or exterior purposes and is specifically designed to hide imperfections on pre-cast concrete ceilings and walls. It can also be used for decorative purposes as it leaves the surface with a very attractive finish.

SPECIFICATION OR RECOMMENDED PAINT SYSTEM :

SURFACE PREPARATION:

a) New plaster, cement renderings and concrete : Brush down or scrape to remove all plaster or hard mortar splashes and other surface contamination. Ensure surface is dry or properly cured. Make good any cracks and repair any defects to match porosity and profile of surrounding areas.

b) Previously painted masonry surfaces : Scrape or brush down to remove all loose and flaking paint or strip back if necessary to a firm base. Make good all cracks and surface defects. Loose and powdered surfaces should be brushed down with a stiff fibre brush and sealed with Warrior Alkali Resistant Plaster Primer or Warrior Bonding Liquid.

FINISHING :

  • Apply one coat of Warrior Alkali Resistant Plaster Primer and allow it to dry.

Finish off with one coat of Warriortex™ Roll-on by applying with a steel trowel, block brush or sheepskin roller and pattern with the Polyurethane foam roller to required textured finish.

PROPERTIES :

APPLICATION:

  • Sheepskin Roller and Polyurethane foam roller
  • Steel towel/block brush and
  • Polyurethane foam roller

CLEANING SOLVENT: Water

THINNING SOLVENT: Not recommended

SPREADING RATE: Spreading rate will depend entirely on the pattern to be formed with the paint, but an average of 1m²per litre can be expected

DRYING TIMES:

  • SURFACE DRY : 2-4 hours
  • HARD DRY : 24 hours

PACK SIZE: 5L, 25L

COLOUR RANGE: Off White only (colours on request)

VISCOSITY: Thick-Paste-Consistency

FLASH POINT: Non flammable

RELATIVE DENSITY 1,45 + 0,05 kg per litre

FINISH: Matt

GENERAL INFORMATION :

a) A variety of textured effects can be obtained depending on the roller used and the patterning carried out.

b) The product should not be thinned as it is supplied ready for use.

Contact us for the WarriorTex™ Roll-on Paint

Leave a Reply